Configure Localino Anchors

You only need this chapter if you are using the Localino App.

Configure Localino Anchors

1. Open a floor

2. Click on Configure floor [A]

   ▷ The sidebar changes.

3. Click on Start calibration [B]

   ▷ Note: If you see the message [G], anchors have already been configured for this floor.

4. In field [C1], specify how high (in meters) the floor of the selected floor is above the ground.

5. In field [C2], specify how high (in meters) the ceiling of the selected floor is above the ground.

6. Click on [C3]

   ▷ The options for the next step appear

7. In [D1], select at least 2 anchors

8. Optional: Activate [D2] to filter the list of anchors so that only anchors that are compatible with the previously made entries are displayed.

9. Click on [D3]

   ▷ The anchors [E] appear in the viewport. Individual anchors are displayed as red dots [E1]

10. Drag and drop the anchors into the desired position. The position of the anchors in Eliona must correspond as precisely as possible to the position of the hardware devices.

    ▷ You can only move/rotate/scale the anchors as a whole. You cannot edit individual anchors. The position of the respective anchor points to each other was previously determined in the Localino app.

    ▷ You can also rotate and scale the anchor arrangement. If necessary, use [E2] and [E3] to make fine adjustments.

11. Click on Save [F]

    ▷ The settings are applied

Adjust Localino Anchors afterward

You can adjust the configuration of the Localino anchors afterward.

1. Open a floor

2. Click on Configure floor [A]

   ▷ The message [G] appears in the sidebar. If this message is missing, no anchor calibration has been carried out yet.

3. Click on Reset [G1]

   ▷ The message [H] appears

4. Click on [H1]

   ▷ The position of the anchors is reset.

   ▷ All possibly connected Localino trackers are no longer displayed.

5. Proceed as described in the chapter ↗ Configure Localino Anchors.